Interior Demolition in Richmond Hill
Interior demolition for homeowners and renovators preparing for a new kitchen, bathroom or full floor renovation. We strip rooms back to the studs and subfloor and carry the debris out, in homes across Richmond Hill and nearby towns.
How we do it
Interior work is quieter than a full teardown but needs more care. The photos on this page show typical rooms we open up: a shower gutted to its studs and plumbing, a bathroom stripped to the subfloor with the vanities and lower drywall gone, a brick arch taken out by hand, and plaster chipped from an inside brick wall.
We start by protecting everything that is staying. Floors in hallways get covered, doorways get dust barriers, and the route to the truck is planned so debris does not travel through finished rooms. Before any wall comes open, the water supply to the room is shut off and electrical circuits in the area are confirmed off.
Older homes can have asbestos in plaster, drywall compound, flooring or pipe wrap. If your house is old enough for that to be a concern, a survey is done first, and any hazardous material is removed by a qualified abatement contractor before our crew begins. That order matters for your family's safety as well as ours.
Most rooms are stripped by hand with bars, hammers and small power tools. We remove tile, drywall, plaster, cabinets, fixtures and flooring down to the level your contractor has asked for, and we cap or tag any plumbing and wiring we expose. Load-bearing walls are never touched without the engineer's or designer's plan in hand.
Debris goes out in bags and bins, with metal separated where possible. At the end we sweep and vacuum so your renovator can start measuring right away. For outdoor work, see deck, fence and outdoor structure removal. Larger commercial interiors are covered under commercial strip-outs.
Before we visit
Help us understand your scope
- What stays?
Note structures, finishes and landscaping that need protection.
- How do we reach it?
Describe stairs, gates, shared driveways and space for loading.
- What is already known?
Share available plans, building rules and survey information. Unknowns can wait for assessment.
Find your next project decision
Compare what stays, what comes out and what the next contractor needs. You can use the short enquiry at any point.
Shared rooms and facilities
- Closed clinic renovation: ordinary removal after specialist clearance
- Condominium common-area refurbishment: planning the demolition
- Private training rooms: planning an interior refit
- Former childcare space: what can ordinary demolition cover?
- Community-facility refurbishment: ordinary rooms and retained building features
- Pool-area refurbishment: ordinary interiors around a retained pool
Offices and tenant changes
Shops, food and customer spaces
Access for the next contractor
- Demolition before several vacant apartments are renovated
- Basement strip-out before interior waterproofing
- Apartment riser renewal: planning the interior openings
- Ordinary interior demolition after a restoration release
- Building-services upgrades: when interior removal is part of the project
- The demolition contribution to a commercial-to-residential conversion
Connected home renovations
- Garage conversion: define the removal while retaining the building
- Planning demolition for an accessible home renovation
- Whole-house interior removal for a substantial renovation
- Interior demolition for a home energy retrofit
- Floor removal before subfloor and joist repairs
- Removing duplicated interiors when a house becomes one home
- Interior removals when two condo suites become one home
What to expect
- 1
Walk-through
We confirm which rooms, which walls and what finish level you need.
- 2
Written scope
The scope lists each room, protection and how debris leaves the house.
- 3
Protection and shut-offs
Floors and doorways are covered and water and power to the area are isolated.
- 4
Strip-out
Finishes, fixtures and drywall come out by hand, down to the agreed level.
- 5
Broom-clean handover
Debris is hauled and the space is swept and vacuumed for the next trade.
Photos from our jobs
Interior Demolition Interior Demolition Interior Demolition Interior Demolition Interior Demolition Interior Demolition
Still deciding what comes out?
- Not sure what demolition service to choose?
- Can I enquire before my renovation drawings are final?
- How do I explain two renovation options without mixing them up?
Two ways to get started
Use a short enquiry if you know the scope, or build a summary with a few guided questions.
Questions from Richmond Hill homeowners
- Do I need a permit for interior demolition?
- Removing finishes like tile, cabinets and drywall usually does not. Removing or altering a load-bearing wall, or work that is part of a larger renovation, generally needs a building permit from the City of Richmond Hill, which your designer or contractor normally applies for.
- How do you control dust inside the house?
- We seal doorways with plastic barriers, cover floors along the path to the door and clean as we go. Rooms outside the work area stay closed off.
- What if you find asbestos?
- Work stops in that area. The material is assessed and removed by a qualified abatement contractor under O. Reg. 278/05 before we continue.
- Can you remove a brick arch or a plaster wall?
- Yes. The photos on this page show both. That kind of work is done by hand so the structure around it is not disturbed.
Related services
Commercial Strip-Outs
Retail and industrial units stripped back for the next tenant.
Deck, Fence and Outdoor Structure Removal
Decks, fences, sheds, chimneys and backyard stonework removed with care.
Ready for a site visit?
We look at the job in person and follow up with a written scope.